Ponoko - All items tagged with polargraph

Polargraph gondola parts 3mm material

euphy — Sun, 13 Nov 2011 20:34:53 GMT

The flat parts to make up a hollow-centre gondola for a polargraph drawing machine. This needs 3x 6003Z bearings and a length of 16.67mm diameter pipe for the centre.

Polargraph Sprocket 5mm Axle

euphy — Fri, 20 Jan 2012 09:44:53 GMT

This is a sprocket for a Polargraph machine. It is designed to mount onto a 5mm stepper motor shaft, and drive beaded cord. Google polargraph for more information. For printing, the units are in mm.

P1 Mr Stu Fat & Fatter Polargraph Gondolas

TeamTeamUSA — Wed, 24 Oct 2012 07:55:15 GMT

Stuart Childs' Fat & Fatter polargraph gondolas laid out on P1 material. Designed for 3mm acrylic material. NOT TESTED AT PONOKO YET! USE AT OWN RISK. More info: http://stuartchilds.com/2012/03/polargraph-drawbot-pen-holder/ Photos ©2012 Stuart Childs

P1 Mr Stu Fat & Fatter Polargraph Gondolas w/ "Push It!" Technology

TeamTeamUSA — Thu, 17 Jan 2013 19:14:46 GMT

TeamTeamUSA says "Push It!" Stuart Childs' Fat & Fatter polargraph gondolas laid out on P1 material. This design has the experimental Push It! (tiltable) technology. Designed for 3mm acrylic material. Successfully tested using clear 3mm acrylic! See photos for drawings. Derived from: http://stuartchilds.com/2012/03/polargraph-drawbot-pen-holder/

Polargraph NEMA-17 stepper motor mount 3mm material

euphy — Sun, 30 Dec 2012 15:51:43 GMT

Parts to mount a NEMA-17 stepper motor to a surface with it's drive axle pointing towards the surface. This is designed to hold the driving motors for a polargraph drawing machine. It is specced to be cut from a 3mm material, so if you would like to use something thicker, it'll need adjustment.