Ponoko

Veneer MDF - White Oak

0.224 inches

555_edges_usa_white_oak_large
There are 5 images for this material

What is it

An MDF core with a 0.5mm real timber veneer on each side.

How fast will this material ship?

Orders using this material will ship as fast as same day. Find out more.

Can I get a sample?

You can get a sample here.

Design Notes

Veneered MDF has a high grade appearance and is consistent in thickness. Laser cuts with a dark edge and engraving does not go through to the MDF.

Grain direction will always run horizontal as drawn on the computer screen.

The manufacturers tolerance for the thickness of the materials is as follows:

Material thicknessPossible Range
inchesmm
0.224” / 5.7mm0.202” - 0.247”5.1 - 6.3mm


Engraving Veneered MDF

There are 3 types of engraving possible with laser cutting. Area engraving, line engraving and a combination of both.

Area engraving is great it you need to mark a large area on the surface of the material. To specify area engraving set your shapes to have a fill color of black with RGB values of 0, 0, 0. The way this engraving is performed is like an old dot matrix printer except instead of dots of ink it uses pulses of the laser beam. This is a surface finish not deep enough to be used for pocketing or inlays. The depth of the engraving ranges between 0.2-0.5mm.

Line engraving is like a really shallow cut. To achieve this effect the stroke color to red with RGB values of 255, 0, 0 and set the stroke style to a width of 0.01 mm. The laser beam follows along the red lines that you have in your design and marks the surface of the material. The result is crisp but it can be a time consuming technique if you have a lot of small details like text.

Using a combination of both engraving types typically gets the best result. Set your shapes to have a fill color of black with RGB values of 0, 0, 0, the stroke color to red with RGB values of 255, 0, 0, and set the stroke style to a width of 0.01 mm. The line engraving causes the laser beam to trace around the edges of the engraved areas making them more crisp and bringing the details to life.

Typical Uses

Veneered MDF is commonly used for making coasters, clocks, furniture, wall art, signage, etc. Not suitable for exterior use.

Environmental Information

Veneers sourced from species not on the 'World List of Threatened Trees’. Compliant with the California Air Resources Board Phase 1 Formaldehyde Emission Standards for Hardwood Plywood (HWPW), Particleboard (PB), and Medium Density Fiberboard (MDF)

Adhesives, joints and fastenings

Construction adhesives will bond MDF well. Follow the adhesive manufacturer's instructions for application processes. Screw joints should be pre-drilled to avoid splitting.

Tips from other designers

None-set-small
Scott says:

I noticed on my sample that the wood color is significantly lighter on the back (with the adhesive covering removed) compared to the front - even in areas where there was no engraving nearby. Is this usual?

Added over 1 year ago. ( delete )
500px_logo-01_small
Dan says:

As the veneers are real wood there will be some natural variation. We try to source veneers that are as close as possible on both sides but inevitably there will be some differences.

Added over 1 year ago. ( delete )
None-set-small
Scott says:

As a note - my sample measured .244in/6.22mm thickness.

Added over 1 year ago. ( delete )

Sign up for our newsletter
to get special offers: