Acrylic - White

0.118 inches 0.177 inches 0.220 inches 0.354 inches

There are 5 images for this material

What is it

Acrylic (PMMA) is a thermoplastic that is available in a wide range of colors including transparent tints and clear to opaque solid colors.

Acrylic has a thickness tolerance of +/-15% of the material thickness.

Orders using this material will ship as fast as same day. Find out more.


Design notes

Acrylic is hard and stiff as plastics go. It is sensitive to stress concentrations sharing a certain fragility with glass. This is most evident if parts are small or thin. Details should not be smaller than 1mm/0.04" as they are likely to be too fragile.

Acrylic retains detail when laser cut and it engraves well. For tips on engraving see this blog post.

Adding radii to corners can reduce the risk of breaking. For some tips on how to design for acrylic see this blog post.

Acrylic can scratch easily and should be cleaned with a mild solution of dish detergent and warm water. Never clean with a other cleaners not suitable for acrylic or with a dry cloth.

Please note: The laser cuts at a slight taper (1-2 degrees) since the laser beam is shaped like a cone. The tapering causes one side to be slightly smaller than the other side. The taper is almost unnoticeable in 1/8" material; the thicker the material, the more noticeable the taper. When using laser-cut parts such as wheels or gears, you might need to position the parts in an alternating pattern so that the tapers “cancel out”.

Typical uses

Acrylic is commonly used as signage, glazing and in building applications, fabricated point of sale displays, menu holders, display cabinets, machine guards, furniture inserts, aquariums & fish tanks, jewelry and tableware.

Environmental info

Acrylic is non toxic and recyclable in some areas.

Adhesives, joints & fastenings

Acrylic can be joined with epoxy, Weldon 3, 16 and 40. Dichloromethane and chloroform. Screw joints should be pre-drilled to avoid splitting.

Tips from other designers

Gregg says:

Has anyone actually verified if this is really 9mm?

Added over 5 years ago. ( delete )
Matt says:

Does anyone know if an LED behind a 3mm thick piece will be visible?

Added almost 5 years ago. ( delete )
JEREMY says:

Can you write on top with permanent ink / paint pen?

Added 26 days ago. ( delete )

Sign up for our newsletter
to get special offers: