Bamboo - Blonde - 3 Ply
What is it
Three layers of bamboo veneer cross laminated to produce a plywood board.
How fast will this material ship?Orders using this material will ship as fast as same day. Find out more.
Can I get a sample?You can get a sample here.
Design NotesA golden color with a fine grain. The bamboo joints are visible on the surface and break up the grain creating a unique appearance.
Sometimes sheets of this material may not be very flat when we get it from the manufacturer. Unfortunately, this is the nature of material. The inherent tension in the grain of the wood and the way it is constructed means the panels can warp after manufacturing.
Be aware of this when designing for this material. If possible arrange your designs on P1 sized templates.
Grain direction will always run horizontal as drawn on the computer screen.
The manufacturers tolerance for the thickness of the materials is as follows:
|Material thickness||Possible Range|
|0.264” / 6.7mm||0.237” - 0.290”||6.0 - 7.4mm|
Engraving BambooBamboo is a natural material with natural variation, one of the big challenges is that as we burn off a layer of the material the nature of the layer below it can vary. Sometimes that next layer comes through very dark and sometimes it comes through lighter - or even banded due to the grain differences. We constantly calibrate our laser settings to ensure we’re producing consistent engraving results. However, it should be noted that there may be differences between the bamboo that you receive and the photos shown on this page.
There are 3 types of engraving possible with laser cutting. Area engraving, line engraving and a combination of both.
Area engraving is great it you need to mark a large area on the surface of the material. To specify area engraving set your shapes to have a fill color of black with RGB values of 0, 0, 0. The way this engraving is performed is like an old dot matrix printer except instead of dots of ink it uses pulses of the laser beam. This is a surface finish not deep enough to be used for pocketing or inlays. The depth of the engraving ranges between 0.2-0.5mm.
Line engraving is like a really shallow cut. To achieve this effect the stroke color to red with RGB values of 255, 0, 0 and set the stroke style to a width of 0.01 mm. The laser beam follows along the red lines that you have in your design and marks the surface of the material. The result is crisp but it can be a time consuming technique if you have a lot of small details like text.
Using a combination of both engraving types typically gets the best result. Set your shapes to have a fill color of black with RGB values of 0, 0, 0, the stroke color to red with RGB values of 255, 0, 0, and set the stroke style to a width of 0.01 mm. The line engraving causes the laser beam to trace around the edges of the engraved areas making them more crisp and bringing the details to life.