Ponoko

Acrylic XT - film LS white, translucent

0.004 inches

Plexiglas_xt_folie_transluzent_wei__05_kante_large
There are 5 images for this material

What is it

Acrylic sheets have universal applications: for lightweight constructions in model making or visual displays, in picture frames or glazing as well as for making signs and light boxes.

The quality we offer (LS) is especially suitable for lampshade designs.

Acrylic semi finished products do not turn yellow in the sunshine. This makes them perfect for outdoor use. Because acrylic glass is subject to thermal expansion, any fixing or mounting systems must be so designed that the sheets are never under stress.

Acrylic glass should not be cleaned with glass cleaners like Sidolin because they can corrode or deface it. Warm water with detergent or special plastic cleaners should be used.

Acrylic glass is a great light guide or conductor. This attribute makes it an interesting and versatile material for use in lamps and other lighting devices. It should be noted, however, that the material absorbs the light over its surface and radiates it outwards at the edges (the edges are bright when seen from the side). The lighted surface should therefore never be masked or covered. Milled cuts will also emit the light when a sheet is backlit. You should be careful when choosing a lighting medium, keeping in mind that the maximum allowable temperature for acrylic glass is between 70C and 80C.

The cast PMMA (GS) lends itself to machining much better than the extruded (XT) version. Because of this, we only recommend the use of the extruded material when not very much boring, milling or turning is planned. Choosing the more economically priced acrylic XT makes the most sense when it is to be used for glazing, picture frames, in simple model making and anywhere else where untreated surfaces are to be used. As far as the eye can tell there is no difference in transparency between the two types.

Acrylic has a thickness tolerance of +/-15% of the material thickness.

Design notes

Please note: Engraving is not recommended for Acrylic XT film. Because of the heat generated in the engraving, the material gets deformed. The engraved therefore is usually not flat but wavy.

Adhesives, joints & fastenings

Acrylic glass XT sheets can be glued with Dichloromethane, and reshaped or deformed at temperatures between 150C and 160 C. Acrylic films can be nicely cut with a blade and the edges can be rounded off using a hot-wire cutter.

Tips from other designers


Sign up for our newsletter
to get special offers: