Ponoko

Ultrasonic Range Finder - Maxbotix LV-WR1

Cost: $99.95 each

044434_file
There are 4 images for this hardware

Description: This is the new, weather resistant, field-hardened WR1 from Maxbotix. The WR1 uses a robust PVC housing, is designed to meet IP67 water intrusion, and matches standard electrical 3/4" PVC pipe fittings. We are extremely pleased with the size, quality, and ease of use of this low voltage weather-resistant range finder. The serial interface is a bit odd (it's RS232 instead of standard TTL), but the PWM and Analog interfaces will allow any micro to listen easily enough. The sensor provides very accurate readings of 0 to 254 inches (0 to 6.45m) in 1 inch increments with little or no dead zone!

Maxbotix is offering the EZ0, EZ1, EZ2, EZ3, and EZ4 with progressively narrower beam angles allowing the sensor to match the application. Please see beam width explanation below.

Control up to 10 sensors with only two pins! Checkout the Maxbotix FAQ listed below.

Detailed dimensional is found in the datasheet below.

Mounting hardware is found here.

Features:

  • 42kHz Ultrasonic sensor
  • Operates from 3-5.5V
  • Low 2.1mA supply current
  • 20Hz reading rate
  • RS232 Serial Output - 9600bps
  • Analog Output - (Vcc/512)/inch
  • PWM Output - 147uS/inch
  • Designed for outdoor applications


Documents:

Checkout Mikey Sklar's flame-based trampoline, the high-lighter, using the EZ1!

SKU: SEN-09009


Sign up for our newsletter
to get special offers: