RedBoard - PCB Add-on for Breadboard Kit
Cost: $14.95 each
Description: Have you already built your RedBoard Breadboard Kit but want to make it more permanent? This kit allows you to take all of the parts you already have from the RedBoard Breadboard Kit and, with some through-hole soldering, turn them into a shield-compatible development board!
Note: This kit is intended as an add-on to the RedBoard Breadboard Kit. If you don't have the parts from that kit, you will not be able to complete this one. If you haven't made the breadboard version and want to skip straight to the through-hole kit, check out the RedBoard PTH Kit below.
- 1 x SparkFun Red PCB
- 1 x MCP1700 3.3V Voltage Regulator
- 1 x Diode 1N4001
- 1 x Resettable Fuse PTC
- 1 x 28-Pin DIP Socket (To seat your ATMega)
- 1 x Push Button Reset Switch
- 2 x 6-Pin Female Headers
- 2 x 8-Pin Female Headers
- 1 x 6-Pin Right Angle Header (To connect your FTDI Basic)
- 1 x 0.1uF Capacitor
- 1 x DC Barrel Jack